Pendaflex Invoice Box

Artist:

Jessica Barnett

Estimated Time:

1 Hours

Difficulty:

Intermediate

Step-by-Step Instructions

Use the ruler to measure all sides of the box that will be covered with paper. Use the paper trimmer to cut all the pieces of paper to size and run them through the Xyron 9" Creative Station
Attach the papers to the outside of the box and trim with a craft knife if necessary. If you would like, you can remove the clasp from the side of the box and replace it after you have attached the paper. If any of the pieces of paper are too large to run through the Xyron 9" Creative Station, attach them to the box using the 2” or 3/8” Adhesive Runners.
Add binding tape to the seams of the box for added interest and to cover up any rough spots on the paper.
Take a scrap of the paper that’s left over and use the stamps and ink pad to spell out a label for the front of the box. Tear the edges of the paper around the stamped image, then ink the edges of the paper with the ink pad. Run this label through the Xyron 9" Creative Station and attach it to the front of the box.