Baby Carriage Card

Artist:

Elizabeth Bracco

Estimated Time:

1 Hours

Difficulty:

Intermediate

Step-by-Step Instructions

Use the Xyron Creatopia with the Cutz component and straight blade cartrdige to cut base of card from coordinating cardstock 5 1/2” x 8 1/2” .
Use the scoring blade cartridge for the Xyron Creatopia Cutz and score cardstock base at 4 1/4” The card should now fold in the middle and be 5 1/2” x 4 1/4”
Using the straight blade and the Creatopia Cutz to cut one of the coordinating pattern papers to 5 1/4" x 4".
Use the Xyron Creatopia Shapez to die cut a coordinating piece of pattern paper with the label die and cut a coordinating piece of cardstock using the scallop circle die and Creatopia. (I used the medium Stackz instructions). Cut a piece out of the scallop circle as shown in the sample.
Run both cut pieces of the pattern paper thru the Xyron Creatopia using the Permanent Adhesive cartridge. Layer onto the center of the card as shown in the sample.
Cut a small scrap of fabric using scissors. Use the Xyron 3/8" Adhesive Runner to adhere to the front of the cut scallop circle and fold end over to backside of scallop circle. Use pop-dots or foam tape to attach scallop circle to card front.
Run chipboard scroll thru the Xyron Creatopia using the Permanent Adhesive cartridge and apply glitter to adhesive side. Run the scroll back thru the adhesive. This time put glitter side up. Adhere scroll the card front just under the scallop circle to make the carriage handle.
Using the Xyron 3/8” Adhesive Runner attach the buttons and flat back pearls to card front making the carriage wheels.
Wrap ribbon around card front flap and tie into a bow.
Using the Xyron Creatopia Shapez and the small tag die cut a coordinating piece of cardstock. Stamp sentiment onto tag. Slide safety pin thru tag and pin to center of bow.