We've used a Xyron 850 for years with the LAT201 laminate/adhesive back cartridge. I just ran 10 sheets of paper through the 850 and had problems with the sheets not feeding straight. Some sheets seemed to have gone through ok. I left it sitting for a half hour or so, then when I came back to the ones I had done, just about all of them seemed to have buckled. I.e., the laminate had pulled away from the paper in a strip around the center (going down vertically). I didn't think that this had happened during the laminating process, but maybe it did.
I also noticed that the few that did come out ok seem to not have sharp adhesion to the paper. There seemed to be small bubbles, giving the laminate a cloudy look.
Is our 850 too old and unable to apply enough pressure? Or is the laminate too old?
Thanks for your help!
I would call their customer service, they would take care of you. Sounds like a bad refill.
Sounds like there is something wrong with the cartridge. Please call customer service and they will help you troubleshoot. 1-800-793-3523
Xyron Tech Support
Xyron Design Team Member