The attached file is a driver that will allow Create and Cut users to control the pressure and speed of the Wishblade within Create and Cut.
NOTE: After downloading and installing the drivers you must follow the directions below to manually change the force in the software.
MAC
To have the ability to adjust speed and cut depth/pressure within the Create and Cut software, copy over the CSM file into the Output Drivers folder. Here’s how:
PC
To have the ability to adjust speed and cut depth/pressure within the Create and Cut software, copy over the CSM file into the Output Drivers folder. Here’s how:
NOTE: After downloading and installing the drivers you must follow the directions below to manually change the force in the software.
MAC
To have the ability to adjust speed and cut depth/pressure within the Create and Cut software, copy over the CSM file into the Output Drivers folder. Here’s how:
- Be sure the Create and Cut software is closed before adding this file.
- Download the file called Xyron.csm to your desktop by clicking "SAVE". Use a program such as stuffit to unzip the download.
- Go into Applications>Xyron Create and Cut>Output Drivers {In the Output Drivers folder there is a file called pmcutter.dll}
- Move or copy the Xyron.csm file to this folder.
- Re-open Create and Cut and type the word “TEST” and select the Cut/Plot button (looks like an X-Acto/Craft knife). The Cut Plot dialog will load. Select the Advanced tab and click the “Cutter Driver Options” Button. Change the force setting to “3” and Save and select OK. (If you do not see the Force setting, click on the RESET button in the bottom right corner).
PC
To have the ability to adjust speed and cut depth/pressure within the Create and Cut software, copy over the CSM file into the Output Drivers folder. Here’s how:
- Be sure the Create and Cut software is closed before adding this file.
- Download the file called Xyron.com to your desktop by clicking "SAVE". Unzip the download by using winzip to unzip the file.
- Go into C:Program Files>Xyron Wishblade Create and Cut 8.1v1>Output Drivers {In the Output Drivers folder there is a file called pmcutter.dll}
- Move or copy the Xyron.csm file to this folder. Select "Yes" when asked to replace the original file.
- Close your window.
- Go to start / programs /wishblade 8.1v1/ preference manager.
- Select factory default and load.
- Open Create and Cut. Type the word “TEST” and select the Cut/Plot button (looks like an X-Acto/Craft knife). The Cut Plot dialog will load. Select the Options tab and click the EDIT button. Change the force setting to “3” and save and select OK. (If you do not see the Force setting, click on the RESET button in the bottom right corner).
