Use the paint and paintbrush to put a coat of black paint on the bottom edge, side panels, top edges, and back outside panel. (Scrapbook paint dries very quickly because it has less water).
Use the ruler to measure three rectangles of paper to fit the fronts of the three panels and cut them from the paper using the trimmer. (We will trim them to fit the angles later). Run these rectangles through the Xyron 9" Creative Station and attach them to the front side of the panels.
Use the craft knife to trim off the excess paper along the angles.
Wrap a piece of ribbon around the holder to measure for length, then cut it. Run the ribbon through the Xyron 1.5" create-a-sticker and attach it to the bottom of the latter holder, approximately 1” up, with the seam in the front near the right side.
Run the vinyl label and clock embellishment through the Xyron 150 also and attach them over the seam of the ribbon.
