Begin by laying the front and back ends of the filer holder over the back side of the patterned papers and trace the curve onto the paper. Use scissors to cut away the paper, just inside the pencil lines. Hold the cute pieces up against the sides to be sure that they will fit, then use them to cut identical pieces out of the solid cardstock.
These pieces will go on the inside of the box, and may need to have approximately ¼” trimmed off the height because of the bottom on the inside. Run all pieces through the Xyron 9" Creative Station, then attach to the file box.
Take the third piece of patterned paper and trim it to fit the width of a file folder. Use the Xyron 2” Adhesive Runner to attach the paper to the front side of the folder. Fold approximately 2” of the paper and attach it to the inside of the folder. Take the 4” wide strips of paper and attach them (folded in half) to the top edges of the folders after running them through the Xyron 9" Creative Station.
Use the Xyron 2” Adhesive Runner to attach the 2” strip of paper to the front of the file box. Tie one end of the ribbon into a knot with a short tail and attach it to the front of the box, over the strip of paper with the Xyron 3/8” Adhesice Runner and trim the end.
Layer the paper flower, die cut flower and fabric covered brad to make an embellishment. Use adhesive dots to attach the flower embellishment under the ribbon. Cut the scrap of paper to fit the chipboard center of the metal label.
Run the paper through the Xyron 1.5" create-a-sticker and attach it to the chipboard oval, then attach the oval to the center of the metal label and place the label on the file folder in front.
