Pendaflex Magazine Holder

Artist:

Jessica Barnett

Estimated Time:

0.5 Hours

Difficulty:

Beginner

Step-by-Step Instructions

Use the ruler to measure the width and height of the front and back of the magazine holder and use the trimmer to cut the two pieces of patterned paper to size. Lay the magazine holder down on the backside of the papers to mark the curves with a pencil. Use scissors to cut around the curves. (If you would like you can ink the edges of the paper now).
Use the trimmed pieces of paper and pencil to trace the shape onto the pieces of cardstock. Run the pieces of patterned paper and cardstock through the Xyron 9" Creative Station and attach them to the inside and outside of the magazine holder.
I trimmed a piece of scrap paper to fit behind the label frame and attached it to the back side of the frame (after inking the inside and outside edges of the frame).
I chose a letter and attached it to the center of the scrap paper/frame with the 3/8" Adhesive Runner, then sanded it to give it a distressed look.
Punch a hole in the top of the label and run the fiber through it, then tie the fiber to one of the sides of the binder clip. Attach the binder clip to the top of the magazine holder.