Pendaflex Large Paper Sorter

Pendaflex Large Paper Sorter

Pendaflex Large Paper Sorter

Artist:
Jessica Barnett
Estimated Time:
1 Hours
Difficulty:
Intermediate

Step-by-Step Instructions

  1. Use the ruler to measure the height of the side of the paper holder (allowing for a small border around the edge) and cut four of the pieces of paper to fit that height using the paper trimmer.
  2. Lay the paper holder on top of the trimmed pieces of paper and use a pencil to trace the curve onto the backside of the paper. Trim away the excess paper using scissors. Use these same methods to cut papers for the inside pieces, but be sure to remove them from the holder first and allow for extra space at the top and bottom of these pieces because they have to be able to fit back inside the slots of the holder.
  3. Use the Xyron 2” and 3/8” Adhesive Runners to attach the papers to both sides of the ends and middle dividers. If there is any excess sticking up over the sides, use a craft knife to trim.
  4. Run a piece of ribbon along the curved edge of the holder and cut to length. (you will need two of these pieces). Run the ribbon pieces through the Xyron 1.5" create-a-sticker and attach to the two curved end pieces. At the tightest parts of the curves, you will need to use your scissors to cut small slits into the ribbon so that it will lay flat on the plastic.
  5. Take the two flowers and fold them in half. This allows you to cover a bigger area with them and also makes them look fuller. Use dimensional adhesive dots to hold them in a folded position, then use more of the dots to attach them to the side of the paper holder. Use the dots one more time to attach the label on top of the flowers.

Xyron Products Used

Scroll for More

Other Products Used

  • Oxford® DecoRack®
  • 8 Sheets of 12"x12" Patterned Paper
  • 1 Spool of 2" wide Ribbon
  • 6 Strips of 4"x12" Patterned Paper
  • 1 Strip 2"x12" Patterned Paper
  • 1 Coordinating Label
  • Craft Knife
  • Paper Trimmer
  • Ruler
  • Adhesive Foam Dots

Comments