Fall Party Invitation

Artist:

Sandy Clements

Estimated Time:

2 Hours

Difficulty:

Intermediate

Step-by-Step Instructions

Open the design templates in Xyron Create and Cut Software. Choose Cut. Cut 4 of each color item. Ink edges of all cut items (optional)
Fold the large yellow piece to form the card. Place the Cut Maroon/ Striped cardstock items, the yellow printed paper pieces and the teal/green piece through the Xyron 9” Creative Station with permanent adhesive.
Adhere the Maroon/ Striped cardstock items near the bottom of the card as shown. Adhere the large red cardstock pieces with foam Mounting tape to the top and bottom on the card.
Adhere the yellow leaf/swirl with foam mounting tape in the top center portion of the card.
Adhere the large yellow printed paper rectangle to the bottom of the card as shown. Adhere the orange paper leaf with foam mounting tape to the bottom left corner.
To create the leaf charm: If using shrink paper, first print the word “Fall” using the Xyron Design Runner and the Occasions disk, on the leaf cut from shrink paper. Using a heat gun heat the leaf until it has shrunk down - or follow the manufacturers directions using a conventional oven.
If using vellum, cut 2 additional leaves from red cardstock. Print the word “Fall” using the Xyron Design Runner and the Occasions disk, on one of the leaves cut from red cardstock. Place the vellum leaf through the Xyron adhesive machine. Adhere on top of the printed red cardstock leaf. Using foam-mounting tape adhere it on top of the second red cardstock leaf.
Place a jump ring through the hole in the charm. Tie the charm to the card on the middle right section through the two cut holes using the gold floss/fiber.