I just bought the pink Wishblade yesterday, unpacked and installed Create and Cut Plus 1.0. I am running Windows 7 (64bit). The software installed fine. Windows recognizes the Wishblade as "USB Printing Support" however and when I follow the manual for "Output Preferences" I cannot choose Xyron Wishblade. I googled for info as well as looked on here and found this forum talking about how the Wishblade is not compatible with Win 7 (64 bit) systems.
http://forum.make-the-cut.com/discussion/3185/need-help-with-pink-wishblade-make-the-cut/
Is this true? If it's not, how do I fix this?
Also, when I turn on the Wishblade it goes thru this whole warming up back and forth arm up and down thing, then rests and about 1-2 minutes later does it again in the same pattern. Is this normal? If it's not, how do I get it to stop? I can't imagine that I have to have the Wishblade turned on so that my laptop can recognize it and yet while I'm working it keeps going off every minute or so.
Thanks!
Brig
Tell your friend about this page! Simply enter your information into the fields below and click the Send button once you're done.
Thank you for sharing Xyron products with your friends. Your e-mail has now been sent. Here's how it will look when your friend receives it.
